Coated Wall Systems

Coated Wall Systems

For special applications in commercial/industrial facilities, the protective concrete coatings installed on the concrete floors need to extend onto the walls. We will wrap or tie the wall and ceiling into the floor and base in addition to rounding the inside corners. This helps to eliminate the cracks and small pockets that harbor dirt, dust, and potentially harmful bacteria. Extending your concrete floor coating up onto the wall results in a seamless, easy-to-clean and maintain high-performance surface.

We specialize in installing the following wall systems:

  • Epoxy / Urethane / Urethane Hybrid
  • Smooth Troweled CMU Epoxy Systems
  • Fiberglass Reinforced Epoxy
  • Fiberglass May Layup Systems

*All Seamless, hygienic, and available with antimicrobial topcoats.

Facility Types

  • Bakeries
  • Breweries
  • Canneries
  • Dairies
  • Farms
  • Food Storage / Silos
  • Granaries
  • Greenhouses
  • Grow Facilities
  • Mills
  • Process Plants

Frequently Asked Questions

  • How do high-performance wall coatings differ from standard commercial paint?

  • Can a coated wall system connect to the floor to create a seamless, easy-to-clean transition?

  • What is an integral cove base, and when should it be included?

  • Can coated wall systems be installed over existing concrete block or previously coated walls?

  • When would a facility need a reinforced wall system rather than a standard wall coating?

How do high-performance wall coatings differ from standard commercial paint?

High-performance wall systems are selected for specific demands such as repeated cleaning, chemical exposure, abrasion, or impact. They can involve different primers, resin builds, and reinforcement than conventional paint. Performance depends on the complete system and substrate preparation, not simply on applying a thicker finish coat.

Can a coated wall system connect to the floor to create a seamless, easy-to-clean transition?

Yes, compatible floor and wall systems can be detailed to form a continuous transition. The design must account for the substrate, movement, moisture, and cleaning conditions. A continuous finish can reduce hard-to-clean junctions, but joints and other necessary movement details still require appropriate treatment.

What is an integral cove base, and when should it be included?

An integral cove base extends the flooring system up the wall with a curved transition at the floor-to-wall junction. It can make cleaning easier than a sharp corner and is often considered in wet or hygiene-sensitive areas. Height, radius, and termination details should be coordinated with the facility's requirements.

Can coated wall systems be installed over existing concrete block or previously coated walls?

Often, but the wall must be suitable for the selected system. Concrete block may need filling or surfacing, while existing coatings require evaluation for adhesion and compatibility. Moisture, contamination, and loose material must be addressed. The preparation and primer are selected for the actual substrate rather than appearance alone.

When would a facility need a reinforced wall system rather than a standard wall coating?

Reinforcement may be considered where the wall needs greater resistance to impact or where the specified assembly calls for it. Substrate joints, movement, cleaning exposure, and the required finish also influence selection. Reinforcement is part of a designed system; it does not eliminate structural movement or make every substrate suitable for coating.

Ready to Get Started?

If you are looking for an experienced, detail orientated, fast responding team, contact us through our form or call us today.

Idaho Address

901 E Karcher
Nampa, Idaho 83687

CONTACT IDAHO TEAM

Washington Address

5913 NE 127th Ave
Vancouver, WA 98682

CONTACT WASHINGTON TEAM

Contact Us

Please contact our team of experts using the form below.